Carcass & sizes
- W × H × D per cabinet number
- Panel thickness vs spec
- Squareness of the box
TapePhoto ref
Cabinets & joinery · Foshan & Guangdong
Kitchen Cabinet & Joinery Inspection in China
Kitchens, wardrobes, vanities and built-ins checked cabinet by cabinet against your drawings and hardware schedule.
Factory check only. Site fit is confirmed after installation, not here.
CoveredKitchen, wardrobe, bathroom, built-ins
ИсточникDrawings, cabinet list, hardware schedule
ПодтверждениеEvery cabinet number measured and photographed
BoundarySite fit only after installation
The thread we follow
Drawing → cabinet number → measurement → trial fit
- 1
Чертёж
Revision number and cabinet list agreed before the visit.
- 2
Cabinet number
Each unit found, labelled and matched to the drawing.
- 3
Measurement
Sizes, gaps and panel thickness against the stated tolerance.
- 4
Trial fit
Runs dry-fitted, doors and drawers cycled, hardware counted.
Side by side
The drawing beside the piece
Key dimensions stay as text in the report; the drawing opens at full size.
Illustrative drawing
Checked per cabinet
Carcass to carton
Tolerances come from your drawings, not a generic standard.
Doors & fronts
- Gaps and alignment
- Edge banding, corners, chips
- Colour and sheen vs sample
Sample in frameRaking light
Фурнитура
- Brand and model vs schedule
- Hinge and slide count per unit
- Soft-close works, holes drilled
Open / close video
Trial assembly
- Runs dry-fitted on the floor
- Left / right hand as drawn
- Fillers and end panels present
Run photographed
Labels & packing
- Room + cabinet code on every carton
- Hardware bagged per cabinet
- Fronts protected, corners guarded
Before closureClosed carton
One line per cabinet
- Cabinet number, spec basis, observed, status
- Held units listed with the photo
- Site-only items marked "not checked"
Example record
Cabinet, spec basis, observation, status
- Cabinet numberAs on the drawing and the carton
- Spec basisDrawing revision, schedule or sample code
- ObservationWhat was measured or seen
- StatusPass, fail, hold, pending or not checked
IllustrativeCabinet numbers, tolerances and readings are fictional.
| Шкаф | Spec basis | Observed | Status |
|---|---|---|---|
| KC-03 · width | Drawing R02: 900 ±2 mm | 900 mm | Этап |
| KC-03 · door gap | Drawing R02: 3 mm | 5 mm, upper edge | Fail · D-01 |
| WR-01 · hinges | Schedule: 2 soft-close per door | 2 per door, soft-close works | Этап |
| KC-07 · edge banding | Sample EB-02 | Chipped corner, right side | Приостановлено |
| KC-07 · packing | Order packing list | Not yet packed | Pending |
| All · site fit | Site survey | Outside factory scope | Not checked |
Real orders use your drawing's tolerances.Report template
Boundaries
What can be confirmed where
At the factory
- Sizes vs drawing, per cabinet
- Door gaps on a flat bench
- Hardware brand, model, count
- Finish and edge banding vs sample
- Trial assembly of runs
- Labels, hardware bags, packing
Only after installation
- Fit against site walls and floors
- Appliance clearances
- Plumbing and electrical cut-outs in place
- Final door alignment on site
- Worktop seams and sealing
Cabinets & joinery
Send the drawings and the cabinet list
We confirm which cabinets one visit can cover, and quote in writing.